Welcome, Guest. Please login or register.
Did you miss your activation email?
May 01, 2025, 04:53:18 pm
Home Help Search Login Register

Ottawa Fiero Club Forum  |  Buy/Sell/Trade  |  Parts  |  Topic: Fuel Pump/Sending Unit assembly « previous next »
Pages: [1] Go Down Print
Author Topic: Fuel Pump/Sending Unit assembly  (Read 1742 times)
dguy
Global Moderator
OFC Post-a-holic
*****
Offline Offline

Posts: 2598


Got vacuum. Want boost.
« on: March 28, 2010, 08:45:44 pm »
Does anyone happen to have a dead fuel sending unit assembly lying around that they'd care to part with?

While re-calibrating the sending unit & replacing the fuel pump for our current project I misplaced one piece of the darn thing.   Roll Eyes  It's likely not crucial; just a small metal cover of sorts over the back plane of the sending unit's resistor wafer.  Given how much fun a fuel tank drop is however I'd rather err on the "safe" side of better-safe-than-sorry... 
Logged
1984: Track car project.
1985 SE: Dead 2.8, stalled L67 swap.
2ML67
Guest
« Reply #1 on: March 29, 2010, 01:58:29 pm »
Have a few up in the rafters but I can not remember if they have good sending units for the gauge or not. Will climb up later and check. Dan
Logged
Pages: [1] Go Up Print 
Ottawa Fiero Club Forum  |  Buy/Sell/Trade  |  Parts  |  Topic: Fuel Pump/Sending Unit assembly « previous next »
Jump to:  


Powered by MySQL Powered by PHP Powered by SMF 1.1.18 | SMF © 2013, Simple Machines Valid XHTML 1.0! Valid CSS!