Welcome, Guest. Please login or register.
Did you miss your activation email?
May 01, 2025, 08:28:16 am
Home Help Search Login Register

Ottawa Fiero Club Forum  |  General  |  General Chat  |  Topic: Starting problem « previous next »
Pages: [1] Go Down Print
Author Topic: Starting problem  (Read 1806 times)
drebac
Guest
« on: October 08, 2010, 02:05:56 pm »
I have a 85 fiero 2.5l 5 speed manual transmission, the car was running but its seem after the engine is warm it cuts out for a while if you let it cool down it would start but now the starter turns but the engine does not fire.  The fuel filter was replaced, fuel conical spray seen.  ignition wires, cap and rotor replaced no spark at spark plug. input to ignition coil checked 12v seen at input side when ignition on.  checked the coil input 1.5ohms output hv 8000 ohms.  In my manual there are no wiring diagrams does anyone know where i could get one.
Logged
aaron88
Ottawa Fiero Member
OFC Post-a-holic
******
Offline Offline

Posts: 1642


Kempvision
« Reply #1 on: October 08, 2010, 11:38:33 pm »
http://www.fieronews.net/fusion/downloads.php
Logged
Your only limitations are set from within, by a lack of vision.  But to have vision alone leaves the process idle.  Ergo, without action your thoughts are worthless.
Pages: [1] Go Up Print 
Ottawa Fiero Club Forum  |  General  |  General Chat  |  Topic: Starting problem « previous next »
Jump to:  


Powered by MySQL Powered by PHP Powered by SMF 1.1.18 | SMF © 2013, Simple Machines Valid XHTML 1.0! Valid CSS!