Ottawa Fiero Club Forum

General => Pictures => Topic started by: FieroBUZZ on October 10, 2003, 09:32:23 pm



Title: Qvestion???
Post by: FieroBUZZ on October 10, 2003, 09:32:23 pm
Anyone see any promise in something like this?  

Strictly a roadster, the black 'side windows' are plexi side curtains pushed into slots on the door to ease wind on the highway. Just a tonneau cover for protection.   Part of the rear is kept to provide a top seat belt bolt point.  Also a short rear window to cut down on backdraft from the rear deck.


Title: Re:Qvestion???
Post by: WillEV on October 11, 2003, 11:42:47 am
Very nice !


Title: Re:Qvestion???
Post by: 2ML67 on October 11, 2003, 03:18:10 pm
Nice when do we start building one or are you not into using either a grinder, a cutting torch or should we go all out and use a plazma cutter. Damn I think I just found my winter project. Might practice on a parts car. Dan


Title: Re:Qvestion???
Post by: FieroBUZZ on October 12, 2003, 07:32:05 am
Here's a revision with a hump that's a little less 'busy'. Not sure about the wing, though.

Dan, are you saying that I'm afraid to cut up my car?  :-*
Snag is that I don't weld, and it will need a brace under the subframe.

Gary


Title: Re:Qvestion???
Post by: FieroBUZZ on October 12, 2003, 07:45:05 am
No wing.


Title: Re:Qvestion???
Post by: lsixtyseven on October 12, 2003, 11:04:26 am
Try chopping the windshield, see how that looks.


Title: Re:Qvestion???
Post by: BootMachine on October 16, 2003, 04:53:12 pm
LOWER AND WITH NO WING!  ;D