|
Title: GT Quarter windows Post by: dimeadozen on June 10, 2010, 01:28:38 pm I have a set of GT quarter windows and I thought they would bolt up in the back the same way as the Se triangle windows did inside the pillars.
But I see that they don't... Are they just glued? can I yankem? Title: Re: GT Quarter windows Post by: 2ML67 on June 10, 2010, 07:46:46 pm On the notchies there is a bolt that comes in through the side that needs to be dealt with by removing the interior trim piece that the seat belt goes through. Dan
Title: Re: GT Quarter windows Post by: can machine on June 10, 2010, 10:11:24 pm The GT's are held on by two sided tape. If the windows are still good I would use a hair dryer to heat them a bit when your yanking them.
Title: Re: GT Quarter windows Post by: dimeadozen on June 10, 2010, 11:27:05 pm Nice. Thanks guys. Gonna rip em out tomorrow
Title: Re: GT Quarter windows Post by: aaron88 on June 12, 2010, 12:24:11 pm At some point ( I don't know when) GM started to put a wire built into the installaion. You pull the wire which cuts the tape. Then when you re-install you put an new wire back in.
Aaron . |