Welcome, Guest. Please login or register.
Did you miss your activation email?
May 16, 2024, 01:12:09 pm
Home Help Search Login Register

Ottawa Fiero Club Forum  |  Buy/Sell/Trade  |  Parts  |  Topic: Northstar 4 sale in Indiana « previous next »
Pages: [1] Go Down Print
Author Topic: Northstar 4 sale in Indiana  (Read 1021 times)
GSXRBOBBY
Guest
« on: September 05, 2004, 09:06:38 pm »

1993 Cadillac Seville STS 4.6L Northstar V-8

This is a complete 1993 Cadillac 4.6L 32 valve Northstar engine
from a Cadillac Seville STS. It is a stock L37 300 h.p./295 ft.
torq. motor. The 8th digit in the vin will be a Y or 9. Y motors
are 275 hp and 9 motors are 300 hp. These motor is a "9"! It
was pulled from a stolen recovery vehicle with minor damage.
It has about 105,000 miles on it. It was running before it was
pulled from the car. Comp. test is good.It is holding oil and turns
over without a problem.

APPEARANCE:
The motor has been cleaned very well and a few items on the
motor has been repainted since it was going to be installed in a
"Show car". The top plate has also been polished to a chrome
finish, about 6 hours of my time.

CONDITION:
On the wiring harness there is one connector off the wiring harness
that has damage "smashed" to it from when it was removed from
the car.

WHAT YOUR BUYING:
What is included is: The motor, the ECM "computer", wiring
harness, starter, oil cooler and lines, alternator, plugs and
wires, throttle cable, A/C compressor, power steering pump,
coil pack, motor mount, flexplate, battery cables, exhaust
manifolds and 3" Y pipe, water pump, belts and some of the hoses.

WHAT IT CAN BE USED IN:
The motor will fit in any Cadillac 93-95 with the ECM being
used as far as I have been told. The motor will work in a 96 - 99,
but the 93's ECM will have to be used.

ALTERNATIVE USES:
The computer chip has been reprogrammed to bypass the passkey,
the Cadillac transaxle, and a few other needed things so it will run in
a non-Cadillac vehicle such as a Fiero, Monte Carlo, Grand Prix,
hot rod, sandbuggy, or dunebuggy.

WHY IT IS FOR SALE:
The motor was bought to be swapped into a
Fiero. I have desided to put the swap off for a couple of
months until money is alot more steady in the summer time.
"Seasonal work sucks!"

WHAT I ASK OF YOU:
Buyer pays for and arranges shipping, shipping cost is going
to be around $75-$200. The complete motor weight is about
425 with everything on the motor.
Only people with good remarks should bid, I will leave feed
back!!! After the time has ended I will require $100.00 as a
nonrefoundable down payment. I will then require the remander
of the final sales price 1 week, "7 days" later.

PAYMENT:
I do have a Paypal account "which I perfer", I will take a money
order, or I will take a check but will ship the motor after it clears.
Oh, ya! Cash always works!!!

CONTACT:
If you have any questions write me at
thespeedshop@sbcglobal.net as a last resort call my cell
phone #(219)808-8076 My name is Bobby.


ADDITIONAL:
Just to say it before its asked the stand is not included
in this sale. Since I am not doing the install it will be
sold as-is! Good luck bidding!!!

LOCATION:
I can also find other deals if this sells before
we workout a deal. I'm in N.W.Indiana, about 20 mins.
away from Gary & Merrilliville and about 2 hours north of Indy.
About 2 hours west of Fort Wayne, 4 hours from Detroit, MI



Any pictures can be looked at and/or found on my build site here.
Or I can e-mail more if needed!
Logged
GSXRBOBBY
Guest
« Reply #1 on: September 07, 2004, 10:43:33 pm »

I put it on Ebay tonight.
http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&item=7920907231
Logged
Pages: [1] Go Up Print 
Ottawa Fiero Club Forum  |  Buy/Sell/Trade  |  Parts  |  Topic: Northstar 4 sale in Indiana « previous next »
Jump to:  


Powered by MySQL Powered by PHP Powered by SMF 1.1.18 | SMF © 2013, Simple Machines Valid XHTML 1.0! Valid CSS!