Ottawa Fiero Club Forum

have 5 rear bearings; (why an odd number I can only guess  ::) ) don't need fiero bearings with the .... changes I am doing.
They all seem to be in decent usable shape.  First come, first chooses.  
$10 each?
I also have some fiero brake rotors and calipers; some axle ends; some other parts; various condition but most in useable shape.  

I WILL BE AWAY FOR A FEW DAYS SO DON'T PANIC IF YOU DON'T HEAR BACK RIGHT AWAY; I WILL GET BACK TO ANYONE LEAVING A MSG.
thanks!
gp

I would like some "like new" rear hubs. Do the have any play or make any sounds when spun?

Do you have some manual tranny complete axles?

Cheers!
Eric

Put me down for one, preferably two.

ok; done;
Eric: I have two axles from my 85 4spd; the bearings all seem to be good and tight or I would have tossed them.  (I still don't know why only 5 tho.... ??? )

Don - will reserve two if you want

I will be away so don't panic if no reply for the few days or so

Please do!   :)  Drop me a line when you're back, and I'll swing by on my way home.

DONE
 ;)

here is a BIT of the stuff I have accumulated trying different rear ends and bits and pieces........ if it will attach this time  >:(

Are they the complete axles or just the ends? (need complete)

and how much?

Cheers!
Eric

you need complete with the splined end that meshes with the bearing assy, I am guessing?

I think those ends have been taken off but I should still have them; let me look.
will get back to you.
[startsearchthrugarage].......

Graeme, as for calipers, I'm looking for rears (and rotors I guess) and I think Nick may need fronts.
LMK

I started on the 85, let me know what chunk you want cut out.

hi Gary
they are yours; by this point I don't know what shape they are in
but you can have them.  With a bit of luck they might be useable; they have been sitting for a yr and a half now ........ [sobering thought] sob [/sobering thought]
but they have been INSIDE..... so maybe.
cross your fingies.
I need one control arm plus would appreciate a 'section' of the frame (that is immed above the cradle (so, ie, NOT the upper-most frame) - I just need it to build a jig.  I can come out to do that when I get back; and it might be a good idea; that way i can get the chunk i am after; the control arm will be a ....... well..... to get out anyway i am sure.

checkwith Nick; I am pretty sure one of the fronts is no longer good; I gave mine to someone with a seized or leaky caliper but the other is ok; (same provisions as the rears.....) so tell him to lmk

is he doing that 3.4 swap?
or too busy building a huge garage?
have to go out and patronize their place someday!

ok; we're back. Not easy leaving Punta Cana's 31C for Ottawa's plus 6 or whatever it was........ :o
not to mention the scenery.......... 8)
but back to the car business.
Don; do you want to drop by? Is that convenient? Gary; should I come out?
Eric; do you need the ends on those axles; or do you have anything to put on; they HAVE been taken off and I am not sure I have boots for them; new boots would be a really good idea anyway.........
everyone lmk;
gp

Punta Cana?!?! that's were we went! :)  what Hotel were you at? we went to Carib Club Princess. Awesome!

And i need the complete axles, not concerned about boots. i can get new ones. :)

Cheers!
Eric